Datasheet

Replacing the Console or Auxiliary Cable

If a cable is already connected to the CONSOLE or AUX/MODEM port, follow these steps

to remove it:

1. Turn off the power to the console or auxiliary device.

2. Unscrew the screws that secure the cable connector to the port, using a 2.5-mm

flat-blade screwdriver if necessary.

3. Pull the cable connector straight out of the port.

4. Disconnect the cable from the console or auxiliary device.

To connect the new cable, follow these steps:

1. Plug the female end of the replacement serial cable into the CONSOLE or AUX/MODEM

port (see “Replacing the Management Ethernet Cable” on page 103).

2. Tighten the screws on the connector.

3. Power on the auxiliary or console device.

Figure 44: Console and Auxiliary Serial Port Connector

Documentation

Fiber-Optic and Network Cable Specifications for the M7i Router on page 178•

• M7i Chassis Description on page 6

• FIC Specifications for the M7i Router on page 177

Replacing the SSD on an RE-B-1800 Routing Engine

The RE-B-1800 Routing Engine supports a solid-state drive (SSD) specified by Juniper

Networks and ships with one SSD installed. Figure 45 on page 104 shows the arrangement

of storage drive slots on an RE-B-1800 Routing Engine.

Figure 45: RE-B-1800 Storage Drive Slots

g006581

USB

port

SSD

slot

Console

port

Management

port

Auxiliary

port

Handle

M7i Multiservice Edge Router Hardware Guide