Datasheet

Figure 41: Installing the Routing Engine
Related
Documentation
Preventing Electrostatic Discharge Damage to an M7i Router on page 132•
• M7i Chassis Description on page 6
• M7i Routing Engine Description on page 18
• Maintaining the M7i Routing Engine on page 76
Replacing the Routing Engine Interface Port Cables
The Routing Engine is located on the front of the router, as shown in Figure 1 on page 6.
It houses the Routing Engine interface ports, which accept connections to external
management devices.
To replace the cables connecting to the Routing Engine interface ports, perform the
following procedures:
•
Replacing the Management Ethernet Cable on page 103
•
Replacing the Console or Auxiliary Cable on page 104
Replacing the Management Ethernet Cable
To replace the management Ethernet cable:
1. Press the tab on the connector on the management Ethernet cable and pull the
connector straight out of the port. Figure 42 on page 103 shows the connector.
2. Disconnect the cable from the network device.
3. Plug one end of the replacement Ethernet cable into the MGMT port (see Figure 43
on page 103).
4. Plug the other end of the cable into the network device.
Figure 42: Routing Engine Ethernet Cable Connector
Figure 43: Routing Engine Interface Ports
103Copyright © 2012, Juniper Networks, Inc.
Chapter 15: Replacing M7i Hardware Components