Datasheet

“Upgrading and Downgrading the CFEB and CFEB-E” on page 92. To replace the CFEB

or CFEB-E, perform the following procedures:

•

Removing the M7i CFEB and CFEB-E on page 91

•

Installing the M7i CFEB and CFEB-E on page 92

•

Upgrading and Downgrading the CFEB and CFEB-E on page 92

Removing the M7i CFEB and CFEB-E

To remove the CFEB or CFEB-E (see Figure 33 on page 91):

1. Place an electrostatic bag or antistatic mat on a flat, stable surface.

2. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect

the strap to one of the ESD points on the chassis.

3. Press and hold the ONLINE/OFFLINE button on the faceplate of the CFEB or CFEB-E

until the green OK LED turns off, which takes about 5 seconds.

4. Loosen the thumbscrew on each ejector locking tab (shown in Figure 4 on page 10),

using a Phillips screwdriver if necessary.

5. Pull the ends of the ejector handles outward until they are nearly perpendicular to the

faceplate of the CFEB or CFEB-E.

6. Grasp the ejector handles and pull firmly to slide the CFEB or CFEB-E about halfway

out of the chassis.

7. Place one hand under the CFEB or CFEB-E to support it, slide it completely out of the

chassis, and place it on the antistatic mat or in the electrostatic bag.

CAUTION: When a CFEB or CFEB-E is out of the chassis, do not hold it by

the ejector handles. They cannot support its weight.

Do not stack CFEBs or CFEB-Es on top of or under other components.

Place each one individually in an electrostatic bag or on its own antistatic

mat on a flat, stable surface.

Figure 33: Removing the CFEB or CFEB-E

Chapter 15: Replacing M7i Hardware Components