Datasheet

3. To use the port on the Mini-PIM, you must assign it to a security zone other than the

Null zone. Optionally, you can also assign the port an IP address (for example,

192.168.3.1/24). Enter or select the following settings:

a. Select Configure>Security>Zones/Screens.

b. Add or select a security zone other than Null; for example, Trust.

c. For host inbound traffic, set the following:

•

Services=Allow All

•

Protocols=Allow All

d. Click OK, and click Commit to apply the configuration and other pending changes

(if any).

4. To use the port on the Mini-PIM, you must also set security policies. Select the following

settings:

a. Select Configure>Security>Policy>Apply Policy.

b. Set Policy Action: Default Policy Action=Permit-All.

c. Click OK to save changes, and click Commit to apply the configuration and other

pending changes (if any).

For advanced configuration information, see the Junos OS Network Interfaces

Configuration Guide.

Using the CLI

To perform basic configuration for the 1-Port SFP Mini-PIM and to configure network

interfaces for the services gateway with the CLI:

•

Verify that the 1-Port SFP Mini-PIM is installed on the device:

show chassis hardware

•

Verify the status of the interface:

show interfaces terse

•

Assign the port an IP address:

set interfaces ge-1/0/0 unit 0 family inet address interface address/destination prefix

•

Add or select a security zone; for example, Trust:

set security zones security-zone trust interfaces ge-1/0/0.0 host-inbound-traffic

system-services all

•

Add or select security zones for host inbound traffic protocol options:

set security zones security-zone trust interfaces ge-1/0/0.0 host-inbound-traffic protocols

all

•

Set security policies:

Chapter 8: 1-Port SFP Mini-Physical Interface Module