Datasheet

1-Port Gigabit Ethernet SFP Mini-Physical Interface Module LEDs
The 1-Port Gigabit Ethernet Small Form-Factor Pluggable Mini-Physical Interface Module
(SFP Mini-PIM) has two LEDs located to the right of the socket. Table 23 on page 54
describes the LED states.
Table 23: 1-Port Gigabit Ethernet SFP Mini-PIM LED States
DescriptionStateColorLED
Port is onlineOnGreenLINK
Port is offlineOff
Port is receiving or sending dataBlinkingGreenACT
Port might be on but is not receiving or
sending data
Off
Related
Documentation
1-Port Gigabit Ethernet SFP Mini-Physical Interface Module Overview on page 49•
• 1-Port Gigabit Ethernet SFP Mini-Physical Interface Module Hardware Specifications
on page 50
• 1-Port Gigabit Ethernet SFP Mini-Physical Interface Module Network Interface
Specifications on page 51
• 1-Port Gigabit Ethernet SFP Mini-Physical Interface Module Supported Modules on
page 51
• 1-Port Gigabit Ethernet SFP Mini-Physical Interface Module Key Features on page 53
• 1-Port Gigabit Ethernet SFP Mini-Physical Interface Module Basic Configuration on
page 54
1-Port Gigabit Ethernet SFP Mini-Physical Interface Module Basic Configuration
To enable the 1-Port Gigabit Ethernet Small Form-Factor Pluggable Mini-Physical Interface
Module (SFP Mini-PIM) installed on the SRX Series Services Gateway, you must configure
the properties. You can perform the same configuration tasks using either the J-Web
interface or the CLI. In addition, you can configure a variety of other options that are not
encountered frequently.
•
Using the J-Web Interface on page 55
•
Using the CLI on page 55
Copyright © 2012, Juniper Networks, Inc.54
SRX Series Services Gateways for the Branch Physical Interface Modules Hardware Guide