Datasheet

Using the CLI
To perform basic configuration for the 1-Port ADSL2+ Mini-PIM and to configure network
interfaces for the services gateway with the CLI:
•
Verify that the serial interface is installed on the device:
show chassis hardware
•
Verify the status of the interface:
show interfaces terse
•
Assign the port an IP address:
set interfaces at-1/0/0 unit 0 family inet address interface address/destination prefix
•
Add or select a security zone; for example, Trust:
set security zones security-zone trust interfaces at-1/0/0.0 host-inbound-traffic
system-services all
•
Add or select security zones for host inbound traffic protocol options:
set security zones security-zone trust interfaces at-1/0/0.0 host-inbound-traffic protocols
all
•
Set security policies:
set security policies default-policy permit-all
See the Junos OS Network Interfaces Configuration Guide for more details.
Related
Documentation
• 1-Port ADSL2+ Mini-Physical Interface Module Overview on page 33
• 1-Port ADSL2+ Mini-Physical Interface Module Hardware Specifications on page 34
• 1-Port ADSL2+ Mini-Physical Interface Module Network Interface Specifications on
page 35
• 1-Port ADSL2+ Mini-Physical Interface Module Supported Standards on page 36
• 1-Port ADSL2+ Mini-Physical Interface Module Key Features on page 37
• 1-Port ADSL2+ Mini-Physical Interface Module LEDs on page 37
Copyright © 2012, Juniper Networks, Inc.40
SRX Series Services Gateways for the Branch Physical Interface Modules Hardware Guide