Datasheet

• 1-Port ADSL2+ Mini-Physical Interface Module Key Features on page 37
• 1-Port ADSL2+ Mini-Physical Interface Module LEDs on page 37
• 1-Port ADSL2+ Mini-Physical Interface Module Supported Loopback Diagnostics on
page 38
• 1-Port ADSL2+ Mini-Physical Interface Module Basic Configuration on page 39
1-Port ADSL2+ Mini-Physical Interface Module Key Features
The 1-Port ADSL2+ Mini-Physical Interface Module (Mini-PIM) provides the following
key features:
•
Automatic configuration of the ADSL after negotiating with the DSLAM
•
Support for ADSL, ADSL 2, and ADSL2+ protocols on the same interface card
•
Dying Gasp support
•
MLPPP on one interface
•
Asynchronous Transfer Mode (ATM) Adaptation Layer 5 (AAL5) encapsulation
•
Support of latency modes fast and interleave
•
Support for ATM AAL5 with CBR, VBR-nrt and UBR traffic types
•
Support for 10 permanent virtual circuits (PVCS)
Related
Documentation
1-Port ADSL2+ Mini-Physical Interface Module Overview on page 33•
• 1-Port ADSL2+ Mini-Physical Interface Module Hardware Specifications on page 34
• 1-Port ADSL2+ Mini-Physical Interface Module Network Interface Specifications on
page 35
• 1-Port ADSL2+ Mini-Physical Interface Module Supported Standards on page 36
• 1-Port ADSL2+ Mini-Physical Interface Module LEDs on page 37
• 1-Port ADSL2+ Mini-Physical Interface Module Supported Loopback Diagnostics on
page 38
• 1-Port ADSL2+ Mini-Physical Interface Module Basic Configuration on page 39
1-Port ADSL2+ Mini-Physical Interface Module LEDs
The 1-Port ADSL2+ Mini-Physical Interface Module (Mini-PIM) has two LEDs. Table 16
on page 38 describes the LED states.
37Copyright © 2012, Juniper Networks, Inc.
Chapter 3: 1-Port ADSL2+ Mini-Physical Interface Module