Datasheet

Replacing a Gigabit-Backplane Physical Interface Module in the SRX Series Services
Gateway
This topic includes the following sections:
Required Tools and Parts for Replacing a Gigabit-Backplane Physical Interface
Module on page 22
Preventing Electrostatic Discharge Damage to the SRX Series Services
Gateway on page 23
Removing a Blank Gigabit-Backplane Physical Interface Module Faceplate from the
SRX Series Services Gateway on page 24
Installing a Gigabit-Backplane Physical Interface Module on the SRX Series Services
Gateway on page 24
Installing a Double-High, Double-Wide Gigabit-Backplane Physical Interface Module
on the SRX Series Services Gateway on page 27
Removing a Gigabit-Backplane Physical Interface Module from the SRX Series Services
Gateway on page 28
Required Tools and Parts for Replacing a Gigabit-Backplane Physical Interface Module
The following tools and parts are required for replacing a Gigabit-Backplane Physical
Interface Module (GPIM) on the SRX Series Services Gateway:
Electrostatic bag or antistatic mat, for each component
Electrostatic discharge (ESD) grounding wrist strap
Flat-blade (–) screwdriver, approximately 1/8 in. (3 mm)
Phillips (+) screwdrivers, numbers 1 and 2
Blank panels (if no component is installed)
Related
Documentation
Removing a Blank Gigabit-Backplane Physical Interface Module Faceplate from the
SRX Series Services Gateway on page 24
Installing a Gigabit-Backplane Physical Interface Module on the SRX Series Services
Gateway on page 24
Installing a Double-High, Double-Wide Gigabit-Backplane Physical Interface Module
on the SRX Series Services Gateway on page 27
Removing a Gigabit-Backplane Physical Interface Module from the SRX Series Services
Gateway on page 28
Copyright © 2012, Juniper Networks, Inc.22
SRX Series Services Gateways for the Branch Physical Interface Modules Hardware Guide