Datasheet

NOTE: The interface xe-6/0/0 is the correct configuration if the 2-Port 10
Gigabit Ethernet XPIM is installed in slot 6. If the 2-Port 10 Gigabit Ethernet
XPIM is installed in slot 2 (valid only on SRX650), then the correct interface
configuration would be xe-2/0/0
•
Assign MTU values:
set interfaces xe-6/0/0 unit 0 family inet mtu mtu values
•
Set link options:
set interfaces xe-6/0/0 gigether-options802.3ad/auto-negotiation/ loopback
•
Add or select a security zone; for example, Trust:
set security zones security-zone trust interfaces xe-6/0/0.0 host-inbound-traffic
system-services all
•
Add or select security zones for host inbound traffic:
set security zones security-zone trust interfaces xe-6/0/0.0 host-inbound-trafficprotocols
all
•
Set security policies:
set security policies default-policy permit-all
•
Set operating mode, for example, copper:
set interfaces xe-6/0/0 media-type copper
NOTE: By default, interfaces run in fiber mode at 10 G speed with
autonegotiation.
•
Set interface speed, for example, 10 G:
set interfaces xe-6/0/0 speed 10g
NOTE: For copper ports, all 10 Mbps, 100 Mbps, 1 G, and 10 G speeds are
supported; for fiber ports, only 1 G and 10 G speeds are supported.
Related
Documentation
• 2-Port 10 Gigabit Ethernet XPIM Overview on page 109
• 2-Port 10 Gigabit Ethernet XPIM Key Features on page 110
• 2-Port 10 Gigabit Ethernet XPIM Hardware Specifications on page 111
• 2-Port 10 Gigabit Ethernet XPIM LEDs on page 113
• 2-Port 10 Gigabit Ethernet XPIM Components on page 114
• Installing a Gigabit-Backplane Physical Interface Module on the SRX Series Services
Gateway on page 24
Copyright © 2012, Juniper Networks, Inc.118
SRX Series Services Gateways for the Branch Physical Interface Modules Hardware Guide