Datasheet

•
PRBS 2^31-1
•
QRSS 2^20-1 (as specified in ITU-T 0.151)
•
BERT results should be in the following form:
•
Received bit count
•
Received error count
In conformance with ANSI T1.107-1995, the 1-Port Clear Channel DS3/E3 GPIM supports
both generation and detection of FEAC codes, as well as line-loopback activate and
deactivate control codes.
Related
Documentation
1-Port Clear Channel DS3/E3 GPIM Overview on page 97•
• 1-Port Clear Channel DS3/E3 GPIM Hardware Specifications on page 98
• 1-Port Clear Channel DS3/E3 GPIM Network Interface Specifications on page 99
• 1-Port Clear Channel DS3/E3 GPIM Supported Standards on page 101
• 1-Port Clear Channel DS3/E3 GPIM Key Features on page 101
• 1-Port Clear Channel DS3/E3 GPIM LEDs on page 102
• 1-Port Clear Channel DS3/E3 GPIM Components on page 103
• 1-Port Clear Channel DS3/E3 GPIM Basic Configuration on page 105
1-Port Clear Channel DS3/E3 GPIM Basic Configuration
To enable the 1-Port Clear Channel DS3/E3 GPIM installed on the SRX Series Services
Gateway, you must configure its properties. You can perform the basic configuration
tasks using the CLI. In addition, you can configure a wide variety of options that are not
encountered frequently.
•
Using the CLI on page 105
Using the CLI
To perform basic configuration for the 1-Port Clear Channel DS3/E3 GPIM and to configure
network interfaces for the services gateway with the CLI:
•
Verify that the 1-Port Clear Channel DS3/E3 GPIM is installed on the services gateway:
show chassis hardware
root@srx650r03> show chassis hardware
Hardware inventory:
Item Version Part number Serial number Description
Chassis AJ2210AA0064 SRX650
Midplane REV 09 710-023875 AABJ4077
System IO REV 08 710-023209 AABK2897 SRXSME System IO
Routing Engine REV 18 750-023223 AABJ8853 RE-SRXSME-SRE6
FPC 0 FPC
PIC 0 4x GE Base PIC
FPC 2 REV 03 750-023873 TV4286 FPC
105Copyright © 2012, Juniper Networks, Inc.
Chapter 11: 1-Port Clear Channel DS3/E3 GPIM