Manual

GPS Expansion Pod 9
Aer the seings have been selected, tap on the Apply
Seings buon to save the new seings. Tap on the Get
Seings buon to bring up the GPS pod current seings to
double check them.
Reviewing and Editing the Receiver Parameters
Once you determine which data format you are going to
use, follow these steps to review and edit the parameters
as needed:
1. Click on the Get Seings buon to reset the
parameters to their default seing.
2. Change the parameters, if necessary, by clicking on
the down arrow on the right of the Baud, Parity, Stop
Bits, and/or GPS Data Format box to bring up a list of
seing options, and click on the seing you want.
3. Click on the Apply Seings buon.
4. Click on the Ok in the top right corner to minimize
the program.
5. To completely close the program go to Start > Seings
> System tab > Task Manager. Click End Task.