Manual

6 Field PC GPS Expansion Pod
Reset Receiver
The Reset Receiver buon returns all of the seings on the
GPS receiver to their default seing. This function enables
you to start over in the event that an error was made.
2. Tap on the Get Seings buon and wait approximately
one minute for the seings to appear.
3. Record the seings for the following:
COM Port: COM3—not changeable
Protocol:
Baud:
Parity:
Data Bit: (Note: Data Bit is always set at 8 and is not
shown in the set up)
Sto
p Bit:
The following are the default GPS pod seings:
CO
M Port: COM3 —not changeable
Protocol: TSIP
Baud: 9600
Data Bit: 8—not changeable
Parity: None
Stop Bit: 1
4. Access the setup or conguration menu in the GPS
program.
5. Change the parameters on the GIS/GPS conguration
menu of the program to match the default GPS
Expansion Pod seings or change the parameters on