User Manual

Chapter 2 Standard Features 17
SD Cards
The Mesa 2 has a slot for a micro SD card located in the
battery compartment. The card slot and exible card
holder are designed to hold the card securely in place so it
will not come out or disconnect if the tablet is dropped. To
insert or remove a card follow these step:
1. Power off the tablet.
2. Remove the battery door as outlined in chapter 1.
CAUTION: The Mesa 2 is not sealed against water and
dust when the battery pack and battery door are not
installed properly.
CAUTION: Always power off the tablet before removing
the battery. Failure to do so may cause loss of data or
damage to the tablet. EXCEPTION: If your tablet has an
internal battery, this caution does not apply. You can
safely remove the removable battery while the unit is
running.
3. Remove the battery pack by pulling up on the black tab
on the battery pack.
4. An image on the battery compartment label shows the
correct location and orientation for the SD card (slot on
the right). Pull the exible card holder back out of the
way. Push the card into the slot to insert it.
5. Push the exible card holder back into place, covering
the card slots.
6. Replace the battery pack, and attach the battery door.
To remove the SD card, pull it out. Use tape or an eraser if
you have trouble.
!
!