Owner's manual

LandMark Mobile User’s Manual 57
Could not find Ellipse.dat file.
Ellipse.dat les are datum les saved in the registry. This error
message appears for one of the following reasons:
1. The registry is corrupt, or a clean boot was executed.
2. The program path was modied, so the registry path is no
longer available.
3. The ellipse.dat les were deleted.
To solve the problem, check the registry path. Registry errors
may be xed by doing a reset. If the reset does not work, reinstall
LandMark Mobile.
Error message:
Error Initializing WMM2K - WMM.COF File not found.
WMM is a formula used to calculate magnetic declination from
GPS data. Most receivers do this calculation, but some do not. In
the instance that a receiver does not calculate magnetic declination,
you need to use either Manual Mode, or WMM 2K for calculations.
The error message appears if the WMM.COF le cannot be found.
The following are reasons for not being able to nd the le:
1. The registry is corrupt, or a clean boot was executed.
2. The program path was modied, so the registry path is no
longer available.
3. The WMM.COF le was deleted.
4. The date seing on the Field PC precedes the year 2005.
Registry errors may be xed by doing a reset. If the reset does not
work, reinstall LandMark Mobile.
Error message:
lm.ini File not found - Default values used.
The lm.ini le is where LandMark Mobile’s specications are
wrien. This message appears for one of the following reasons:
1. The registry is corrupt, or a clean boot was executed.
2. The program path was modied, so the registry path is no
longer available.
3. The lm.ini le was deleted.
Registry errors may be xed by doing a reset. If the reset does not
work, reinstall LandMark Mobile.
Error message: