Owner's manual
56 LandMark Mobile User’s Manual
Error and Warning Messages
LandMark Mobile displays pop-up messages when an error occurs.
The following section lists the possible error messages and
suggests how to x the problems related to an error message.
LandMark Mobile Startup Error Messages
The following are the error messages and suggested x for those
messages that may occur during LandMark Mobile startup.
Error message:
Application Path Not Found. Please make sure the path ‘my device\
Program Files\LandMark Mobile’ exists. If it does not, please re-install
LandMark Mobile.
This error message appears for one of the following reasons:
1. The path, my device\Program Files\LandMarkMobile, (the
LandMark Mobile default installation path), was changed
aer installation.
2. You tried to copy the LandMark Mobile folder from another
Field PC. You must use the installation CD to set the path
where the LandMark Mobile is installed on the Field PC.
3. A clean boot (factory default reset) on the Field PC was
performed.
To x the error, reinstall LandMark Mobile onto the Field PC.
Error message:
Error initializing datums. If “3_param.dat” and “7_param.dat” files are
corrupt, re-install, or check for correct application path (\my device
\C_Program Files\LandMarkMobile).
When LandMark Mobile is installed, datum les are saved in the
registry as 3_Param.dat, and ellipse.dat. This error message appears
for one of the following reasons:
1. The registry is corrupt.
2. The program path was modied, so the registry path is no
longer available.
3. The 3_Param.dat, and ellipse.dat les were deleted.
Fix the error by either checking the registry path, or reinstalling
LandMark Mobile.
Error message: