User Manual
Bar Code Expansion Pod 9
displays on the screen approximately 1.5 sections aer
each unsuccessful scan.
Sc
anner Setup
The Scanner tab is used to congure the operation of the
scan engine.
Target Time
The Target Time option allows you to set the amount of
time the target beam is on before a scan is initiated.
The Target Time box shows the time, in seconds, that the
target beam is on. The scroll buons allow you to set the
amount of time the target beam is on before a scan is
initiated. The Target Time can vary from 0.0 to 9.9 seconds,
in 0.1 second increments.
If you set the Target Time at 2.0, that means the target
beam remains on for 2.0 seconds and then turns o as