Instruction Manual

Field PC AMXU GPS Expansion Pod 5
Reference Information
GPS Pod Setup Utility
The internal GPS receiver seings are pre-congured
with the GPS Pod Setup utility as follows:
These seings work for most applications. To make
changes to the default seings, exit all GPS programs
on your Field PC (this is a requirement) and go to Start >
Programs > AMXU Pod Setup.
You can select which NMEA message strings are shown,
enable/disable SBAS (Satellite Based Augmentation
Systems)/WAAS, and indicate whether or not GPS is
always on (see the following page for details).
Check or uncheck options to enable or disable them.
Seing changes are preserved through suspend, resume
and complete power o. To exit the program, select “OK.”