User guide

ManualsBrandsJuniper Systems ManualsEquipmentAllegro Top Mounting Bracket

Installing the Top Mount Bracket on the Allegro

The top mount bracket for the Juniper Systems Allegro can be used

in a variety of mounting applications. Originally designed for a GPS

antenna mated with a separate GPS receiver system, it can also be

used with Bluetooth devices like barcode scanners, RFID readers, and

standalone GPS devices.

Installing the top mount bracket on the Allegro is a simple seven-step

process. To complete this, you will need a thin, narrow, metal object.

Caution: Do not use a sharp knife as this could damage the case.

1. Remove the existing on-board stylus from the top of the Allegro.

Figure 1: Remove stylus from Allegro

2. Loosen the thumbscrews on the bracket until the nuts reach the

top of the threads. It is not necessary to remove the nuts.

Figure 2: Loosen thumbscrews.

3. Place the mount in position at the top of the Allegro with the

at face of the mount close to the same plane as the Allegro’s

display. See Figure 3.

Summary of content (4 pages)

PAGE 1
Installing the Top Mount Bracket on the Allegro The top mount bracket for the Juniper Systems Allegro can be used in a variety of mounting applications. Originally designed for a GPS antenna mated with a separate GPS receiver system, it can also be used with Bluetooth devices like barcode scanners, RFID readers, and standalone GPS devices. Installing the top mount bracket on the Allegro is a simple seven-step process. To complete this, you will need a thin, narrow, metal object.
PAGE 2
Figure 3: Align mounting surface as close as possible to display. Rotate bracket into position. 4. otate the stylus on the mount into place on the Allegro. This will R allow the edge of the small metal bracket to catch the plastic edge of the stylus receptacle. 5. old the stylus firmly in place as you use a thin, narrow, metal H object to work the rubber tabs around the stylus. Do not cut the rubber tabs. 6.
PAGE 3
Installing the Top Mount Bracket on the Allegro The top mount bracket for the Juniper Systems Allegro can be used in a variety of mounting applications. Originally designed for a GPS antenna mated with a separate GPS receiver system, it can also be used with Bluetooth devices like barcode scanners, RFID readers, and standalone GPS devices. Installing the top mount bracket on the Allegro is a simple seven-step process. To complete this, you will need a thin, narrow, metal object.
PAGE 4
Figure 3: Align mounting surface as close as possible to display. Rotate bracket into position. 4. otate the stylus on the mount into place on the Allegro. This will R allow the edge of the small metal bracket to catch the plastic edge of the stylus receptacle. 5. old the stylus firmly in place as you use a thin, narrow, metal H object to work the rubber tabs around the stylus. Do not cut the rubber tabs. 6.