Owner's Manual

Chapter 1 Getting Started 5
3. Place the Li-Ion battery pack in the compartment.
Make sure the + and - symbols on the battery pack
label align with the symbols inside the compartment.
4. Replace the door and tighten the screws.
5. Plug the AC wall power charger that came with the
Allegro 3 into a wall socket. Plug the other end into the
DC power jack on the Allegro 3. The red LED on the
keyboard blinks when the battery pack is charging.
Charge the battery pack for 4-6 hours at room
temperature.
Attach the Hand Strap and Stylus Tether
A hand strap, capacitive blunt tip stylus, and tether are
included with the handheld.
Note: A stylus is not required to use the touchscreen. The
optimal way to make selections is by nger touch.
If the hand strap and stylus are not attached at the factory
or you want to move it to the other side, view the following
image to see how to attach them.
Line up the symbols on the
case and the battery pack
as shown