User's Manual

3. Tap Power Off. A warning dialog appears. Tap OK.
To power on your Surveyor, press the Power button until the amber notification LED comes on.
Resetting the device. When installing programs, you are sometimes required to reset your
device. Follow the steps below to reset the Surveyor:
1. Save open files and close running programs.
2. Press the Power button until the Power Button menu appears.
3. Choose Reset.
If your device locks up, you can reset the device by pressing the Power button for 10 seconds or
until the screen goes dark. After a few seconds, the device turns on again.
Restore factory settings. Follow the steps below to restore the user storage, settings, and icons
on your Surveyor to their original factory defaults.
WARNING! Restoring the Surveyor to its original factory state will permanently erase data
saved on the Surveyor, any software you installed, and any changes you made to the Surveyor,
including settings changes.
To perform a clean boot, which restores everything but the “storage” folder, select reset from
the Power Button menu and immediately press and hold Ctrl + Alt + Del until the splash screen
appears.
To perform a storage clean, which only erases the “storage” folder, select reset from the Power
Button menu and immediately press and hold down Ctrl + Alt + 2 until the splash screen appears.
Using the stylus
Below are directions for performing shortcuts using the stylus.
To do this . . . Follow these steps
Select an item Tap once.
Open an item or file Tap the item or file.
Cut or copy Tap and hold until the context menu appears. Select Cut or
Copy.
Paste Tap and hold the area where you want to paste. Select Paste
from the context menu that appears.
Open a context menu for an item Tap and hold the item. The context menu appears.
Drag and drop Tap and drag the item to the destination and lift up the
stylus.
Select multiple items Drag the stylus over the items.