User's Manual

Regulatory Information
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is used in a commercial or
residential environment. This equipment generates, uses, and can radiate radio frequency energy
and, if not used in accordance with the reference guide, may cause harmful interference to
radio communication. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation of this equipment is subject to
the following two conditions:
1. The device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause
undesired operation.
CAUTION: Only approved accessories may be used with this equipment. In general, all cables
must be high quality, shielded, correctly terminated, and normally restricted to two meters
in length. Wall chargers approved for this product employ special provisions to avoid radio
interference and should not be altered or substituted.
CAUTION: Changes or modifications to the Surveyor that are not expressly approved by the
manufacturer could void the user’s authority to operate the equipment.
Industry Canada
This Class B digital apparatus complies with Canadian ICES-003.
Operation is subject to the following two conditions: (1) this device may not cause interference,
and (2) this device must accept any interference, including interference that may cause undesired
operation of the device.
Industrie Canada
Cet appareil numérique de classe B est conforme à la norme sur le matériel brouilleur canadienne
ICES-003.
Son utilisation doit être soumise aux deux conditions suivantes : (1) cet appareil ne doit pas
générer d’interférence, et (2) cet appareil doit accepter toute interférence captée, y compris celles
qui peuvent nuire à son bon fonctionnement.