Terms and Conditions
Table Of Contents
- Table of Contents
- List of Figures
- List of Tables
- About This Topic Collection
- Part 1: Access Point Overview and Components
- Part 2: Planning for Access Point Installation
- Part 3: Safety Guidelines and Standards for Access Point Installation
- Part 4: Requirements and Certifications
- Part 5: Installing, Connecting, and Verifying the Access Point
- Chapter 7: Installing and Connecting the Access Point
- Installation Instructions Warning
- Unpacking a WLA532E Access Point
- Parts Inventory (Packing List) for a WLA532E Access Point
- Installing the WLA532E Access Point on a Ceiling Rail
- Installing the WLA532E Access Point Using the Plenum Bracket Kit
- Installing the WLA532E Access Point on a Ceiling Rail Using the Trapeze Legacy Mounting Bracket Adapter Kit
- Installing the WLA532E Access Point on the Wall Using the WLA-BRKT-WALL Wall-Mount Kit
- Installing the WLA532E Access Point on the Wall Using the WLA-GNGWLBX-ADP-EU Wall-Mount Kit
- Installing the WLA532E Access Point on the Wall Using the WLA-GNGWLBX-ADP-NA Wall-Mount Kit
- Connecting the Access Point to Wireless LAN Controllers
- Chapter 8: Verifying the Health of the Access Point
- Chapter 9: Customer Support
- Chapter 7: Installing and Connecting the Access Point
Figure 15: Aligning the Plenum Bracket Tabs to Bracket Openings
8. Slide the plenum bracket forward using flanges for leverage until both snaps engage.
Listen for simultaneous clicks that indicate that the snaps have closed and the plenum
bracket is locked.
9. Secure the locked plenum bracket by inserting two M4 screws (not provided) into the
openings on the plenum bracket (see Figure 16 on page 56) using a Phillips number
2 screwdriver.
55Copyright © 2012, Juniper Networks, Inc.
Chapter 7: Installing and Connecting the Access Point