Terms and Conditions
Table Of Contents
- Table of Contents
- List of Figures
- List of Tables
- About This Topic Collection
- Part 1: Access Point Overview and Components
- Part 2: Planning for Access Point Installation
- Part 3: Safety Guidelines and Standards for Access Point Installation
- Part 4: Requirements and Certifications
- Part 5: Installing, Connecting, and Verifying the Access Point
- Chapter 7: Installing and Connecting the Access Point
- Installation Instructions Warning
- Unpacking a WLA532E Access Point
- Parts Inventory (Packing List) for a WLA532E Access Point
- Installing the WLA532E Access Point on a Ceiling Rail
- Installing the WLA532E Access Point Using the Plenum Bracket Kit
- Installing the WLA532E Access Point on a Ceiling Rail Using the Trapeze Legacy Mounting Bracket Adapter Kit
- Installing the WLA532E Access Point on the Wall Using the WLA-BRKT-WALL Wall-Mount Kit
- Installing the WLA532E Access Point on the Wall Using the WLA-GNGWLBX-ADP-EU Wall-Mount Kit
- Installing the WLA532E Access Point on the Wall Using the WLA-GNGWLBX-ADP-NA Wall-Mount Kit
- Connecting the Access Point to Wireless LAN Controllers
- Chapter 8: Verifying the Health of the Access Point
- Chapter 9: Customer Support
- Chapter 7: Installing and Connecting the Access Point
Mounting the device on the exposed ceiling-tile rail is the primary installation method
for the WLA532E. The steps for a concealed plenum bracket ceiling-mount are provided
in this topic. Details about installation and installation kits and other WLA hardware
information can be viewed on the WLA Series Wireless LAN Access Points data sheet
from the WLA Series Wireless LAN Access Points product page and the hardware can be
purchased by contacting a Juniper Partner or a Juniper Salesperson at 1-866-298-6428.
Before installing the access point inside the ceiling :
•
Find a permanent installation location for the WLA532E inside the ceiling. The plenum
bracket requires a ceiling cross-rail for installation.
•
Read “General Safety Guidelines and Warnings” on page 23.
•
Remove the access point from the shipping carton (see “Unpacking a WLA532E Access
Point” on page 44).
Ensure that you have the following parts and tools available:
•
Plenum ceiling-mount bracket (provided)
•
Category 5e cable, installed (not provided)
•
Two M4 screws (provided)
•
Two sheet metal self threading screws ( not provided)
•
Phillips number 2 screwdriver (not provided)
To install the access point on a ceiling cross-rail inside the ceiling:
1. The WLA532E is shipped with an installed diamond mount on the bottom of the
access point for exposed ceiling tile rail installation. For plenum installation inside the
ceiling, you must first remove the diamond by unscrewing the three M4 flat head
screws (see Figure 10 on page 52) using a Phillips number 2 screwdriver. Keep the
screws for later use.
Figure 10: Removing the M4 Flat Head Screws
2. After the screws are removed, separate the open ends of the diamond bracket and
slide it forward to release the bracket snaps. See Figure 11 on page 53.
Copyright © 2012, Juniper Networks, Inc.52
WLA532E Access Point Hardware Documentation