Terms and Conditions
Table Of Contents
- Table of Contents
- List of Figures
- List of Tables
- About This Topic Collection
- Part 1: Access Point Overview and Components
- Part 2: Planning for Access Point Installation
- Part 3: Safety Guidelines and Standards for Access Point Installation
- Part 4: Requirements and Certifications
- Part 5: Installing, Connecting, and Verifying the Access Point
- Chapter 7: Installing and Connecting the Access Point
- Installation Instructions Warning
- Unpacking a WLA532E Access Point
- Parts Inventory (Packing List) for a WLA532E Access Point
- Installing the WLA532E Access Point on a Ceiling Rail
- Installing the WLA532E Access Point Using the Plenum Bracket Kit
- Installing the WLA532E Access Point on a Ceiling Rail Using the Trapeze Legacy Mounting Bracket Adapter Kit
- Installing the WLA532E Access Point on the Wall Using the WLA-BRKT-WALL Wall-Mount Kit
- Installing the WLA532E Access Point on the Wall Using the WLA-GNGWLBX-ADP-EU Wall-Mount Kit
- Installing the WLA532E Access Point on the Wall Using the WLA-GNGWLBX-ADP-NA Wall-Mount Kit
- Connecting the Access Point to Wireless LAN Controllers
- Chapter 8: Verifying the Health of the Access Point
- Chapter 9: Customer Support
- Chapter 7: Installing and Connecting the Access Point
CHAPTER 3
Site Preparation
•
Site Preparation Checklist for the WLA532E Access Point on page 15
•
General Site Guidelines on page 17
•
Environmental Requirements and Specifications for the WLA532E Access
Point on page 18
•
Planning Guidelines for Using RingMaster to Plan a Mobility System on page 18
Site Preparation Checklist for the WLA532E Access Point
The checklist in Table 7 on page 15 summarizes the tasks you need to perform when
preparing a site for WLA532E access point installation.
Table 7: Site Preparation Checklist
DatePerformed ByFor More InformationItem or Task
Environment
“Environmental Requirements and
Specifications for the WLA532E
Access Point” on page 18
Verify that environmental factors such as
temperature and humidity do not exceed access
point tolerances.
Power
Access points require an installed
Category 5 cable.
Measure distance between power source (PoE)
and access point installation site.
“General Site Guidelines” on page 17Locate optimal sites for desired type of
installation.
“Requirements and Specifications
for 2.4-GHz Radios on a WLA532E
Access Point” on page 31
“Requirements and Specifications
for 2.4-GHz Radios on a WLA532E
Access Point” on page 31
Calculate the power consumption and
requirements.
Hardware Configuration
15Copyright © 2012, Juniper Networks, Inc.