Terms and Conditions
Table Of Contents
- Table of Contents
- List of Figures
- List of Tables
- About This Topic Collection
- Part 1: Access Point Overview and Components
- Part 2: Planning for Access Point Installation
- Part 3: Safety Guidelines and Standards for Access Point Installation
- Part 4: Requirements and Certifications
- Part 5: Installing, Connecting, and Verifying the Access Point
- Chapter 7: Installing and Connecting the Access Point
- Installation Instructions Warning
- Unpacking a WLA532E Access Point
- Parts Inventory (Packing List) for a WLA532E Access Point
- Installing the WLA532E Access Point on a Ceiling Rail
- Installing the WLA532E Access Point Using the Plenum Bracket Kit
- Installing the WLA532E Access Point on a Ceiling Rail Using the Trapeze Legacy Mounting Bracket Adapter Kit
- Installing the WLA532E Access Point on the Wall Using the WLA-BRKT-WALL Wall-Mount Kit
- Installing the WLA532E Access Point on the Wall Using the WLA-GNGWLBX-ADP-EU Wall-Mount Kit
- Installing the WLA532E Access Point on the Wall Using the WLA-GNGWLBX-ADP-NA Wall-Mount Kit
- Connecting the Access Point to Wireless LAN Controllers
- Chapter 8: Verifying the Health of the Access Point
- Chapter 9: Customer Support
- Chapter 7: Installing and Connecting the Access Point
Table 5: LED Status and Description of WLA532E
Status and DescriptionColorLabel
No powerOffSTAT
Indicates
access point
status and
power
On. The AP is on power on self-test mode.Flash amber
On. The AP is waiting to receive boot instructions and a configuration file
from a WLC.
Flash green
On. The AP is booting and receiving a configuration file from the WLC. After
the AP boots and receives a configuration, this alternating LED appearance
persists until a radio is enabled.
Flash Green or Amber
On. Powered on and the AP is operational.Green
On. The AP has failed to configure and is not operational.Red
On.. The 2.4GHz Radio is disabled.AmberLED 11BGN
Indicates radio
status and
activity on the
2.4GHz radio.
On. The 2.4GHz Radio is enabled.Green
On. Dedicated sensorAmber
On. The Unit is transmitting/receiving on 2.4GHz radioFlashing Green
On. Radio failed.Red
On. The 5GHz Radio is disabled.AmberLED 11AN
Indicates radio
status and
activity on the
5GHz radio.
On. The 5GHz Radio is enabled.Green
On. Dedicated sensorAmber
On. The Unit is transmitting/receiving on 5GHz radioFlashing Green
On. Radio failed.Red
Related
Documentation
Verifying the Health of WLA Series Access Points Using LEDs on page 77•
MAC Address Information for WLA Series Access Points
Each WLA Series access point is assigned a unique block of 64 MAC addresses. Each
radio has 32 MAC addresses and supports up to 32 service set identifiers (SSIDs), with
one MAC address assigned to each SSID as a basic service set identification (BSSID).
The access point MAC address block is listed on a label on the back of the access point.
9Copyright © 2012, Juniper Networks, Inc.
Chapter 1: WLA532E Access Point Overview