User Manual

Table Of Contents
One 5GHz 3x3 802.11n enhanced power radio subsystem
One Gigabit (10/100/1000 Base-T) Ethernet port
Power consumption within standard 802.3af power on GigE port
Spectrum Analysis
Hardware (DTLS) crypto acceleration for CAPWAP data path
3 spatial stream operation
Rate Adaptation features (3SS rates, 2SS rates and 1SS rates)
The WLA532 can be powered up and operational within 3 minutes and supports all
features of RingMaster and Mobility System Software (MSS).
The following wireless LAN controllers are supported by the WLA532 access point:
WLC2 Wireless LAN Controller
WLC8 Wireless LAN Controller
WLC800 Wireless LAN Controller
WLC880 Wireless LAN Controller
WLC2800 Wireless LAN Controller
Related
Documentation
General Safety Standards and Agencies for the WLA532 Access Point on page 25
Installing the WLA532 Access Point on a Suspended Ceiling Rail on page 33
Installing the WLA532 Access Point on a Wall on page 36
MAC Address Information for WLA Series Access Points
The WLA series access points are assigned a unique block of 64 MAC addresses
(reviewers, please confirm?). Each radio has 32 MAC addresses and hence can support
up to 32 SSIDs, with one MAC address assigned to each SSID as a BSSID. The access
point MAC address block is listed on a label on the back of the access point. If the access
point is already deployed and running on the network, you can display the MAC address
assignments by using the show ap status command using the Mobility System Software
CLI. All MAC addresses for an access point are assigned based on the base MAC address
of the access point as described in Table.
Table 1: MAC Address Information for WLA Series Access Points
DescriptionMAC Address Type
The access point has a base MAC address. All the other addresses are assigned based
on this address
Access Point base MAC Address
Ethernet port 1 equals the access point base MAC address
Ethernet port 2 equals the access point base MAC address + 1 (Not applicable for
WLA532 series).
Ethernet Port MAC Addresses
Copyright © 2011, Juniper Networks, Inc.4
WLA 532 Access Point Hardware Documentation