User Manual
Table Of Contents
- Table of Contents
- List of Figures
- List of Tables
- Part 1: Overview
- Part 2: Planning
- Part 3: Safety
- Part 4: Installation
- Part 5: Troubleshooting
- Part 6: Index
Figure 2: Status LED on WLA532 Access Point
Table 2 on page 8 describes the status LEDs and their states.
Table 2: Status LEDs on WLA532 Access Points
Status and DescriptionColorLabel
Off. The access point is powered off.UnlitLED in
the
center
On. The access point is on power on sand is in self-test mode.Amber, flashing
On. The access point is waiting to receive boot instructions and a configuration file
from a wireless LAN controller.
Cindy, the products are named as WLC2, WLC8 etc. So, is it okay to just say WLC?
Or should we use wireless LAN controller always?)
Green, flashing
On. The access point is booting and receiving a configuration file from the controller.
After the access point boots and receives a configuration file, the LED continues to
flash alternately green and amber until a radio is enabled.
Green or amber, flashing
On. The access point is powered on and is operational.Green
On. The access point has not been configured and is not operational.Red
Copyright © 2011, Juniper Networks, Inc.8
WLA 532 Access Point Hardware Documentation