User Manual

Channelized STM1 IQ PIC (T1600 Router)
•
Junos OS Release 8.5 and later (Type 1)
For information on which FPCs support this PIC, see “T1600 PIC/FPC Compatibility” on page 18.
Software release
•
One STM1 port
•
Power requirement: 0.39 A @ 48 V (18.6 W)
•
Fine-grained queuing per logical interface
•
Channelization: STM1c, fractional E1, framed and unframed DS0
•
Model number: PB-1CHSTM1-SMIR-QPP
Description
•
Packet buffering, Layer 2 parsing
•
Local and remote loopback testing
Hardware features
•
Quality of service (QoS) per channel: weighted round-robin (WRR), random early detection
(RED), weighted random early detection (WRED)
•
SNMP: SONET/SDH MIB, T1/E1 MIB
•
Dynamic, arbitrary channel configuration
•
Full bit error rate test (BERT) patterns at E1 and DS0 levels
•
Encapsulations:
•
High-Level Data Link Control (HDLC)
•
Frame Relay
•
Circuit cross-connect (CCC)
•
Translational cross-connect (TCC)
•
Point-to-Point Protocol (PPP)
Software features
•
Duplex SC/PC connector (Rx and Tx)
•
Single-mode fiber
•
Intermediate-reach fixed transceiver
•
Optical interface specifications—see SONET/SDH OC3/STM1 Optical Interface Specifications
NOTE: This PIC supports only SDH.
Cables and connectors
63Copyright © 2013, Juniper Networks, Inc.
Channelized STM1 IQ PIC (T1600 Router)