Network Hardware User Manual

Appendix B Port Descriptions and LED Status
II User’s Guide
MODULE PORT DESCRIPTIONS
The following table describes the ports on the 5000-M and 5000-M2 management
modules.
The following table describes the ports on the 5000-8G Secure Port Module (SPM).
The following table details the ports on the 5000-2G24FE SPM.
Port Description Type Speed/Protocol
Console Enables a serial connection, to establish terminal
sessions with the system. Used for launching
Command Line Interface (CLI) sessions.
RJ-45 9600 Bps/
RS-232
Modem Enables a serial modem connection for
establishing dial-up sessions.
RJ-45 9600 Bps/
RS-232
MGT Enables a connection for establishing out-of-band
management sessions from outside of the
network.
RJ-45 10/100 Mbps/
Ethernet
HA1 Enables connection with another device in a
redundancy cluster, where one device serves as
the master (primary) device, and the other serves
as the backup (secondary) device.
mini-GBIC 1 Gbps/
Gigabit Ethernet
HA2 Enables connection with another device in a
redundancy cluster, where one device serves as
the master (primary) device, and the other serves
as the backup (secondary) device.
mini-GBIC 1 Gbps/
Gigabit Ethernet
Port Description Type Speed/Protocol
Network
Ports 1-8
Eight 1 Gigabit ports with an aggregate throughput
of 4 Gbps.
mini-GBIC 1 Gbps/
Gigabit Ethernet
Port Description Type Speed/Protocol
Network Ports
1-2
Two high-speed network ports for general
connection to the network.
mini-GBIC 1 Gbps
Gigabit Ethernet
Network Ports
3-26
24 network ports for general connection to
the network.
RJ-45 10/100 Mbps/
Ethernet