Installation Guide

user@host# set wlan access-point name virtual-access-point id maximum-stations
number
f. Commit the configuration:
user@host# commit
See Also
Upgrading the Firmware on the WAP Mini-PIM
To upgrade the firmware on the Mini-PIM, using the CLI:
1. Identify the currently installed firmware version and new firmware version available
for upgrade:
user@host > show system firmware
Part Type Tag Current Available Status
version version
FPC 1
PIC 0 MWAP_FW 1 1.1.2 0 OK
Routing Engine 0 RE BIOS 0 3.1 3.6 OK
Routing Engine 0 RE BIOS Backup 1 3.1 3.6 OK
a. If the Available Version field in the output does not list any information, it indicates
that the device is not running the latest jfirmware. Proceed to Step 2 to download
and upgrade to the latest jfirmware.
b. If the Available Version field in the output lists the firmware version, proceed to
Step 4.
2. Download the appropriate jfirmware version from
https://www.juniper.net/support/downloads/?p=junos-srx#sw:
NOTE: Ensure that the Junos OS version installed on the device is the
same as the jfirmware version or higher. To know the Junos OS version,
issue the show version command.
user@host > request system software add var/tmp/jfirmware-<version>-signed.tgz
3. Verify the new firmware version available:
user@host > show system firmware
The version is displayed under the Available Version field in the output.
4. Upgrade the firmware on the device:
33Copyright © 2019, Juniper Networks, Inc.
Chapter 2: Installation and Configuration