Installation Guide

6. Slide the mini-PIM in until it lodges firmly in the services gateway. See
Figure 3 on page 26.
Figure 3: Installing the WAP Mini-PIM
g022546
7. Using a 1/8-in. (3-mm) flat-blade (–) screwdriver, tighten the screws on each side of
the Mini-PIM faceplate.
8. Attach the antennas to the front panel. You can attach the antenna by using one of
the following methods:
Direct mounting—Attachthe antennas to the RP-SMA connectors on the front panel
of the mini-PIM.
Figure 4: Attaching the Antennas (Direct Mounting)
g022547
Using an antenna base—Attach the antennas to the antenna base. Connect the
cables from each antenna base to the RP-SMA connectors on the front panel.
Copyright © 2019, Juniper Networks, Inc.26
Wireless Access Point (WAP) Mini-PIM Installation Guide