Installation Guide

CHAPTER 2
Installation and Configuration
Installing the WAP Mini-PIM in an SRX Series Services Gateway on page 25
Configuring the WAP Mini-PIM on page 28
Upgrading the Firmware on the WAP Mini-PIM on page 33
Installing the WAP Mini-PIM in an SRX Series Services Gateway
To install the WAP Mini-PIM in a services gateway:
NOTE: You can install only one Mini-PIM in a services gateway. The Mini-PIM
can be installed in any of the Mini-PIM slots on the services gateway.
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
the strap to the grounding point on the back of the services gateway.
2. Power off the servicesgateway by briefly pressing the Power button on the front panel.
Wait for the Power LED to turn off before proceeding. Disconnect the services gateway
from the power source.
3. Remove the blank mini-PIM installed on the services gateway:
a. Loosen the screws on the faceplate of the blank Mini-PIM.
b. Grasp the screws on each side and remove the blank Mini-PIM.
4. Remove the mini-PIM from the electrostatic bag.
5. Grasp the screws on each side of the mini-PIM faceplate and align the notches in the
connector at the rear of the mini-PIM with the notches in the mini-PIM slot in the
services gateway.
CAUTION: Slide the mini-PIM straight into the slot to avoid damaging the
components on the mini-PIM.
25Copyright © 2019, Juniper Networks, Inc.