Installation Guide
Table Of Contents
Figure 2: WAP Mini-PIM Front Panel LEDs
Table 4: WAP Mini-PIM Front Panel LEDs
DescriptionComponentSl. No.
•
Solid green—2G WLAN connection is established
•
Blinking green—Data activity
2.4 GHz1
•
Solid green—5G WLAN connection is established
•
Blinking green—Data activity
5 GHz2
•
Solid green—The mini-PIM is operational
•
Blinking green—Powering on or running diagnostics
STATUS3
WAP Mini-PIM Models
There are three models based on the regional wireless standards.
Table 5: WAP Mini-PIM Models
Notes
Supported
RegionModel
This model is based on the wireless standards
supported in the United States. The country code
is fixed and cannot be changed.
United StatesSRX-MP-WLAN-US
This model is based on the wireless standards
supported in Israel. The country code is fixed and
cannot be changed.
IsraelSRX-MP-WLAN-IL
You can set the country code using the command,
set wlan access-point ap-name access-point-options
country country code
Other countriesSRX-MP-WLAN-WW
Physical Interface
The physical interface for the WAP mini-PIM uses the name wl-x/0/0, where x identifies
the slot on the services gateway where the mini-PIM is installed. You can insert the
mini-PIM in any of the mini-PIM slots on the services gateway.
17Copyright © 2019, Juniper Networks, Inc.
Chapter 1: WAP Mini-Physical Interface Module (Mini-PIM)