- Juniper Router Hardware Guide
Replace Routing E
ngine Components
Figure 41: Insert the PC Card
1333
Replace the Routing Engine
The Routi
ng Engine installs into a slot in the FEB at the rear of the chassis, as shown in
Figure 3. The Routing Engine weighs approximately 3 lb (1.5 kg). To replace the Routing
Engine, perform the following procedures:
• Remove the Routing Engine on page 11 5
• Install the Routing Engine on page 116
Remove the Routing Engine
To remove the Routing Engine, follow this procedure (see Figure 42):
1. Place an electrostatic bag or antistatic mat on a flat, stable surface.
2. On the console or other management device connected to the Routing Engine, enter CLI
operational mode and issue the following command to shut down the router software
cleanly and p reserve Routing Engine state information.
user@host> request system halt
Wait until a message appears on the console confirming that the operating system
has halted.
For m ore information about the command, see the JUNOS I nte rn e t Software O perational
Mode Command Reference: Protocols, Class of Service, Chassis, and M anagement.
3. Press the power switch for both power supplies to the OFF (0)position.OnbothACand
DC power supplies, the switch is located on the power supply faceplate.
Replace Hardware Components
11 5