Internet Router Hardware Guide

Contacting Custom er Support and Returning Hardware
CAUTION: Do not substitute a metric nut driver or wrench. A tool that does not fit
thenutsexactlycandamagethem.Ifa7/16-in.toolisnotavailable,usepliersor
an adjustable wrench.
Blank panels to cover empty slots
Electrostatic bags or antistatic mats, one for each electronic component
removed
Electrostatic discharge (ESD) grounding wrist strap
Flat-blade screwdriver, approximately 1/4 in. (6 mm), for removing craft
interface
Mechanical lift, if available
Phillips (+) screwdrivers, numbers 1 and 2
Rubber safety cap for fiber-optic PICs or PIC cable
Packing the Routing Node for Shipment
To pack the router f or shipment, follow this procedure:
1. Retrieve the shipping crate and packing materials in which the router was
originally shipped. If you do not have these materials, contact your Juniper
Networks representative about approved packaging materials.
2. A tt ach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to one of the ESD points on the chassis. Make sure t he router
is attached to a proper earth ground. For more information about ESD, see
“Preventing Electrostatic Discharge Damage” on page 226.
3. On the console or other management device c onnected to the master Routing
Engine, enter CLI operational mode and issue the following command to shut
down the router software. (If t wo Routing Engines are installed, also issue the
command on the backup Routing Engine.)
user@host> request system halt
NOTE: Wait until a message appears on the console confirming that the operating
system has halted.
For more information about the command, see the JUNOS Protocols, Class of
Service, and System Basics Command Reference.
Packing the Routing Node for Shipment 265