Internet Router Hardware Guide

Connecting the R outer and Performing Initial Configuration
Connect the positive (+) source cable lugs to the return terminals,
which are labeled
RTN(+).
Connect the negative (–) source cable lugs to the input terminals, which
are labeled
–48V.
10. Install another washer and nut (in that order) on each terminal stud to secure
the po wer cable lug. Using a 7/16-in. nut driver or wrench, tighten the nuts.
11 . Verifythatthesourcepowercablingandthegroundingcablingarecorrect,that
they are not touching or blocking access to router components, and that they
do not drape where people could trip on them.
12. Replace the protective shield over the terminal studs and use a Phillips
screw driver to tighten the screw s.
Figure 60: Connecting Power and Grounding Cables
g001226
Terminal studs
Cable lug
Flat washer
Flat washer
To ground
Nut
Nut
Grounding
points
Powering On the R outer
To power on the router, follow this procedure:
1. Verify that the power supplies are fully inserted in the chassis and the
thumbscrews on their faceplates are tightened.
Providing Power to the Router 119