Services Routers Hardware Guide

Table 38: J-series PIM Power Consumption and Heat Dissipation (continued)
TokensPIM Abbreviation
in JUNOS CLI
Model NumberName
HeatHigh PowerLow Power
16216
1x ADSL Annex B
JX-1ADSL-B-SADSL 2/2+
Annex B PIM
(1 port, for ISDN)
10–9
2x SHDSL (ATM)
JX-2SHDSL-SG.SHDSL PIM
(2-port two-wire
mode or 1-port
four-wire mode)
49377
wan-acceleration
ISM-200–WXCWXC Integrated
Services Module
Table 39 on page 74 lists the maximum power tokens and maximum heat tokens
available for each model.
Table 39: Maximum Power and Heat Capacities of J-series Models
Heat Capacity (tokens)
High- Power Capacity
(tokens)
Low- Power Capacity
(tokens)
Model
685050J2320
848484J2350
100100100J4350
100100100J6350
Network Cable Specifications
The Services Router supports interfaces that use various kinds of network cable. For
information about the type of cable used by each interface, see “Network Cable
Specifications and Connector Pinouts” on page 179.
ISDN Provisioning
You might need a network termination type 1 (NT1) device to connect your ISDN
interface to the ISDN service. Contact your service provider for details on the following
information:
■ External NT1 device and ISDN cable
■ If the two items are required, where to obtain the items
■ List of NT1 vendors
74 ■ Network Cable Specifications
JUNOS Software with Enhanced Services Hardware Guide