Services Routers Hardware Guide

Table 45: Configuring Basic Settings (continued)
CLI Configuration EditorJ-Web Configuration EditorTask
Set the address for the backup
router. For example:
set backup router 192.168.2.44
In the Backup router section, next to Address, type the IP
address of the backup router—for example, 192.168.2.44.
Define the backup router
to be used when the
router is booting or the
routing protocol processes
are not running.
1.
From the [edit] hierarchy level,
enter
edit interfaces
2.
Delete the existing IP address:
delete lo0 unit 0 family inet
address
3.
Set the IP address and prefix
length of lo0.0. For example:
set lo0 unit 0 family inet
address 172.16.1.24/32
1.
In the configuration editor hierarchy, next to Interfaces,
click Configure or Edit.
2.
In the Interface table, locate the lo0 row and click Unit.
3.
In the Unit table, click 0, and in the Family section
next to Inet, click Configure or Edit.
4.
To delete the existing IP address, click the Discard
button. Select the Delete Configuration Below This
Point option button from the next display.
5.
Next to Address, click Add new entry.
6.
In the Source box, type the address and prefix length
for the loopback interface—for example,
172.16.1.24/32.
7.
Click OK.
Define the IP address for
lo0.0.
1.
Delete the existing IP address:
delete ge-0/0/0 unit 0 family
inet address.
2.
Set the IP address and prefix
length of ge-0/0/0. For
example:
set ge-0/0/0 unit 0 family inet
address 192.168.1.1/24
1.
In the configuration editor hierarchy, next to Interfaces,
click Configure or Edit.
2.
In the Interface table, locate the ge-0/0/0 row and click
Unit.
3.
In the Unit table, click 0, and in the Family section
next to Inet, click Configure or Edit.
4.
To delete the existing IP address, click the Discard
button. Select the Delete Configuration Below This
Point option button from the next display.
5.
Next to Address, click Add new entry.
6.
In the Source box, type the address and prefix length
for the management interface—for example,
192.168.1.1/24.
7.
Click OK.
Define the IP address for
ge-0/0/0.
Verifying Basic Connectivity and the Configuration
To verify that the Services Router has the settings you configured, perform the
following task:
■ Displaying Basic Connectivity Configurations on page 114
Verifying Basic Connectivity and the Configuration ■ 113
Chapter 6: Establishing Basic Connectivity