Services Routers Hardware Guide

Table 43: Basic Configuration Wizard Summary (continued)
Your ActionFunctionPrompt
To allow you to configure the management interfaces, the configuration wizard presents
the following information. To configure a specific management interface, enter the number
associated with it at the prompt.
Configure the following network interfaces
Identifier...Interface
....1........ge-0/0/0
....2........ge-0/0/1
....3........ge-0/0/2
....4........ge-0/0/3
Would you like to configure any of the above interfaces [yes, no] (yes):
Please enter one or more identifiers of the interfaces separated by comma.
For example, 1, 2
Please select interface identifiers:
For example, if you enter 1, the following text and prompt is displayed:
Configure IP on interface ge-0/0/0
IP address for this interface:
After you enter the IP address, the configuration wizard presents the following prompt:
Subnet mask bit length for this interface [1–32] (32):
After you enter the subnet mask for the interface, the configuration wizard presents the
following prompt:
Enter a security zone name to associate this interface to:
Default Gateway
Type a 32-bit IP address, in
dotted decimal notation.
Defines a default gateway through
which to direct packets addressed to
networks not explicitly listed in the
routing table.
Would you like to configure default gateway? [yes,
no] (no):
If you enter y(es), the configuration wizard
presents the following prompt:
Enter IP address for the default gateway:
New User Account
Configuring Basic Settings Using the CLI Configuration Wizard ■ 109
Chapter 6: Establishing Basic Connectivity