Services Routers Hardware Guide

Table 42: Set Up Quick Configuration Summary (continued)
Your ActionFunctionField
To enable Telnet access, select the check box.Allows remote access to the router using
Telnet.
Allow Telnet Access
To enable JUNOScript access over clear text, select the
check box.
Allows JUNOScript to access the router using
a protocol for sending unencrypted text over
a TCP connection.
Allow JUNOScript
over Clear-Text
Access
To enable SSH access, select the check box.Allows remote access to the router using SSH.Allow SSH Access
Configuring Basic Settings Using the CLI Configuration Wizard
To establish basic connectivity on a Services Router, you must identify the router,
connect the router to the network, and specify basic network settings. This section
explains how to use the command line interface (CLI) configuration wizard for JUNOS
software with enhanced services to configure basic settings so that you can connect
the router to a network and further configure it using the J-Web interface or the CLI.
NOTE: To use the CLI configuration wizard, you must have JUNOS software with
enhanced services installed on your Services Router. If JUNOS software with enhanced
services is not installed on your Services Router, following the instructions
in“Configuring Basic Settings with J-Web Quick Configuration” on page 103 to use the
J-Web Quick Configuration pages to configure basic settings or use the CLI, as
described in “Configuring Basic Settings with a Configuration Editor” on page 110.
About the CLI Configuration Wizard
The JUNOS software with enhanced services configuration wizard is a command line
interface application that allows you to configure basic settings for a Services Router
that is already configured with the factory default settings. For details on factory
default settings, see the JUNOS Software Administration Guide.
Understand these configuration wizard characteristics before using the wizard:
■ Because the configuration wizard overrides any existing configuration, it is meant
to be used on a router configured with the factory defaults only.
■ The configuration wizard shows default values in parenthesis ( ).
■ At any time during the configuration you can type a question mark (?) to obtain
Help.
■ To terminate the configuration at any time without completing it, press Ctrl+c.
■ After you complete the configuration, the wizard allows you to review it before
committing it on the router.
106 ■ Configuring Basic Settings Using the CLI Configuration Wizard
JUNOS Software with Enhanced Services Hardware Guide