Network Scanner Operator's Guide

258
ATTENTION
• Carbonless paper contains chemical substances that may damage the pad
assembly or the pick and other rollers when documents are fed. Pay
attention to the following:
Cleaning:
If pick errors occur frequently, clean the pad assembly and pick roller.
For details on cleaning the pad assembly and pick roller, refer to "Chapter
5 Scanner Care" (page 209).
Replacing parts:
The service life of the pad assembly and pick roller may be shortened
when compared to scanning only wood containing paper documents.
• When wood containing paper manuscripts are scanned, the life of the pad
assembly and pick roller may be shortened compared with the case where
woodfree paper manuscripts are scanned.
• When scanning photographs, the face of the photograph may become
damaged.
HINT
• When scanning semi-transparent documents, set the scan [Brightness] to
"Light" to avoid image bleed through.
• To prevent the rollers from becoming dirty, avoid scanning documents
containing large areas written or filled in with pencil. If scanning of such
documents is unavoidable, clean the rollers frequently.
• To operate correctly, the ADF requires the leading edges of all document
sheets be evenly aligned. Make sure that curling of the leading edge is
within the following tolerances:
More than
30mm
Feed direction
Side being
scanned
Leading edge
of document
Less than 3mm
More than
30mm
Feed direction
Side being
scanned
Leading edge
of document
Less than 5mm