Network Scanner Operator's Guide

6.3 Network Connection Troubleshooting
Network Scanner fi-6000NS Operator's Guide 235
Troubleshooting
6
A results screen similar to the following should appear:
When checking the network connection status of a server by its IP address, the following results
are possible.
Result
Connection
status
Action
"Ping statistics" shows
"Lost=0 (0% loss)"
OK None
"Ping statistics" shows
"Lost=4 (100% loss)"
NG Check that the ping target IP address is correct.
If the ping target IP address is correct, refer to
"Failure to connect to a remote computer using its
IP address" (page 242) for further solutions.
"Ping statistics" shows
"Lost=N (1 to 99% loss)"
NG There may be a quality problem with the LAN
cable. Replace the LAN cable and try again.
In "3.6.11 Checking the Network Operating Status"
(page 89), change the [Link Speed/Duplex Mode]
from "Auto-Negotiation" to a fixed mode.
"Hardware error"
NG The LAN cable may have become disconnected
during the Ping test. Check the status of the LAN
cable and try again.