Network Scanner Operator's Guide

HINT

• If connection to LDAP server is not possible, try the following steps:

1. Disconnect the LAN cable and turn the scanner off.

2. Reboot the scanner with the LAN cable still disconnected, and enter

a nonduplicate IP address.

3. Re-connect the LAN cable to the scanner.

• If the DHCP server cannot be reached when DHCP is set to [On], the IP

Address is set to "169.254.XXX.YYY" (where XXX and YYY are arbitrary

values between 0 and 255).

• If the status of the network connection is correct but the network is not

communicating properly, change the [Link Speed/Duplex Mode] from

"Auto-Negotiation" to a fixed mode.