Quick Start Guide
Table Of Contents
- MP-632
- Package Checklist
- Installing and Connecting an MP
- Installation Requirements and Recommendations
- Installing an MP-632
- Mounting the Unit
- Connecting External Antennas
- Multiple External Antenna Support
- Ethernet
- Connecting Cables to the Unit
- Connecting the Power Injector
- Aligning Antennas for Bridge or Mesh Links
- RSSI Meter Functionality
- Federal Communications Commission Interference Statement (United States)
- Canadian Department of Communications Industry Canada Notice (Canada)
Campus Connectivity MP Quick Start Guide
5
Trapeze Networks
A Campus Connectivity MP (MP-632) can be installed in a variety of locations, both indoors and
outdoors. If the location is set to indoors, then a limited number of available channels are displayed
for configuration. If the location is set to outdoors, only the regulatory allowed outdoor channels
appropriate for the country and domain can be configured on the MP. The default operational mode of
the MP is outdoor.
Indoor locations may include, but are not limited, to the following types:
❑ Locales that require a robust MP for harsh operating environments such as low or high
temperatures.
❑ Warehouse environments
❑ Indoor stadiums or arenas
❑ Auditoriums or very large classrooms
Outdoor locations may include, but are not limited to these following types:
❑ Racetracks
❑ Outdoor stadiums
❑ Construction sites
❑ Outdoor campus areas
MP-632
The MP-632 is a 802.11a/b/g/n AP that is designed for pole-mounting and wall mounting. The MP-632
supports 6 antenna ports, three for the 11a/n radio and three for the 11b/g/n radio. An MX cannot be
used to power this AP. An XPS-6201-OUT or XPS-6202-OUT power supply that uses the IP67
multi-pin DIN connector is required. The MP-632 supports a new set of external antennas that are
commercially available. The MP-632 does not support internal antennas or PoE.
Package Checklist
The MP-632 package includes:
❑ One MP-632 Mobility Point (MP)
❑ Mounting brackets, split washers and mounting hardware
❑ Weather sealing caps for all 6 external antenna connectors
❑ Installation manual
❑ Separate package for XPS-6201-OUT or XPS-6202-OUT campus connectivity power supply.
❑ Circular DIN to RJ45 dongle cable and waterproof caps for RJ45 dongle
❑ Two-hole tabular lug for AWG #8 ground cable
❑ Antenna connector terminator. Any unused antenna connector on an active radio must be
terminated.
Contact Trapeze Networks if there are any incorrect, missing or damaged parts. If possible, retain
the carton, including the original packing materials. Use them again to repack the product in case
there is a need to return it.
W arning!
The MP-632 must only be used with a Trapeze-approved XPS-6201-OUT or
XPS-6202-OUT campus connectivity power supply in order to prevent possible damage
to the unit.