Quick Start Guide
Table Of Contents
- MP-632
- Package Checklist
- Installing and Connecting an MP
- Installation Requirements and Recommendations
- Installing an MP-632
- Mounting the Unit
- Connecting External Antennas
- Multiple External Antenna Support
- Ethernet
- Connecting Cables to the Unit
- Connecting the Power Injector
- Aligning Antennas for Bridge or Mesh Links
- RSSI Meter Functionality
- Federal Communications Commission Interference Statement (United States)
- Canadian Department of Communications Industry Canada Notice (Canada)
Campus Connectivity MP Quick Start Guide
19
Trapeze Networks
Connecting the Power Injector
To connect the wireless bridge to a power source:
1. Connect the Ethernet cable from the wireless bridge to the PoE Output port labeled “POE Output”
on the power injector.
Note:
The Ethernet port on the wireless bridge does not support Power over Ethernet (PoE)
based on the IEEE 802.3af standard. Do not try to power the unit by connecting it
directly to a MX that provides IEEE 802.3af PoE. Always connect the unit to the
included power injector module.
W arning!
The MP-632 must only be used with a Trapeze-approved XPS-6201-OUT or
XPS-6202-OUT power supply in order to prevent possible damage to the unit.
W arning!
Always align the DIN cable with the pins in the PoE Output port. You can bend the
power injector pins and cause other damage to the unit by forcing the cable into the
port.
Note:
The DATA IN port on the power injector is not used.