Quick Start Guide
Table Of Contents
- MP-632
- Package Checklist
- Installing and Connecting an MP
- Installation Requirements and Recommendations
- Installing an MP-632
- Mounting the Unit
- Connecting External Antennas
- Multiple External Antenna Support
- Ethernet
- Connecting Cables to the Unit
- Connecting the Power Injector
- Aligning Antennas for Bridge or Mesh Links
- RSSI Meter Functionality
- Federal Communications Commission Interference Statement (United States)
- Canadian Department of Communications Industry Canada Notice (Canada)
Campus Connectivity MP Quick Start Guide
16
Trapeze Networks
Connecting External Antennas
The supported antennas models are:
❑ 802.11bgn Radio
❍ ANT-7360A-OUT (stick, N-type jack)
If this antenna is used the unused center antenna port must be terminated.
❍ ANT-77555-OUT (3 RP-SMA jack)
❍ ANT-74520-OUT (3 RP-SMA)
❑ 802.11an Radio
❍ ANT-7360A-OUT (stick)
❍ ANT-74520-OUT (3 RP-SMA)
❍ ANT-77555-OUT (3 RP-SMA)
❍ ANT-5007-OUT (2 N-type) - mainly for outdoor application. Band 5150-5250 MHz is not avail-
able for this antenna.
The port usage depends on the antennas in use. If the OMNI antennas are used there must be 3
antennas installed for the radio. If an antenna is used then the two edge ports must be connected to
the antenna (ports 4 and 6). The middle port is turned off by the software and should be terminated. If
either the ANT-77555 or 74520 are used all three connectors must be connected to the MP for the
correct radio.
set ap apnum radio num antennatype {ANT-7360A-OUT | ANT-77555-OUT | ANT-74520-OUT |
ANT-5O07-OUT} …
The antenna location must be either indoors or outdoors. The AP may be used indoors or outdoors.
The following command is per radio.
set ap apnum antenna-location {indoors | outdoors}
Multiple External Antenna Support
The MP-632 supports the use of multiple antenna ports per radio. Since there are always multiple
antennas connected, antenna diversity is always on. The command to set the number of external
antennas does not apply to the MP-632. The number of antenna ports in use is determined by the
antenna type.
Certification Bands Required Application
FCC/IC 2412-2472 MHz Indoor/Outdoor
5150-5250 MHz Indoor
5250-5350 MHz Indoor/Outdoor
5470-5725 MHz Indoor/Outdoor
5600-5650 MHz Disabled
5725-5850 MHz Indoor/Outdoor
W arning!
You cannot configure both outdoor and indoor options for the antenna location.
The operation of antenna ANT-5007-OUT is not allowed in India.