Quick Start Guide
Table Of Contents
- MP-632
- Package Checklist
- Installing and Connecting an MP
- Installation Requirements and Recommendations
- Installing an MP-632
- Mounting the Unit
- Connecting External Antennas
- Multiple External Antenna Support
- Ethernet
- Connecting Cables to the Unit
- Connecting the Power Injector
- Aligning Antennas for Bridge or Mesh Links
- RSSI Meter Functionality
- Federal Communications Commission Interference Statement (United States)
- Canadian Department of Communications Industry Canada Notice (Canada)
Campus Connectivity MP Quick Start Guide
11
Trapeze Networks
Mounting the Unit
You can mount the MP-632 using either the wall-mounting bracket or the wall-mounting bracket
combined with the pole-mounting bracket (brackets are provided for both a 3.81 to 5.08 cm (1.5 to
2-inch) diameter steel pole or tube or a larger size pole or tube). Use one of the following procedures.
Using the Pole-Mounting Bracket
Perform the following steps to mount the unit to a 3.81 to 5.08 cm (1.5 to 2-inch) diameter steel pole or
tube using the mounting bracket:
1. Insert the four large screws (included in kit) through the four circular holes in the bracket as
shown below.
2. Position the flat bracket behind the pole as shown below and align the screws on the front bracket
with the holes in the flat bracket.