User's Manual

Indoor Mobility Point™ Quick Start Guide
8
Trapeze Networks
Installation Requirements and Recommendations
For best results, follow these requirements and recommendations before installing an MP.
RingMaster Network Plan and Work Orders
If you are using RingMaster to plan your Trapeze Networks Mobility System installation, you might
want to create and verify a network plan for the entire Trapeze Network installation and generate an
MP work order before installing MPs. A network plan and the MP work orders generated from it
provide the following information about MP installation and configuration:
❑ Number of MPs required for adequate WLAN capacity in each coverage area
❑ Detailed installation location for each MP
❑ Settings for all MPs in the WLAN
Table 1– 1. MP-522E Trapeze-Approved Antennas
Trapeze Model Number Part Number 2.4GHz /5GHz dBi Gain Antenna Type
Number of
Connectors
Connector Type
ANT-7360A-OUT MMO24580608NF 6/8 Omni 1 N-type Jack
MFB24006 6/no element Omni 1 N-type Jack
MFB24004 4/no element Omni 1 N-type Jack
50 1360 no element/8 Omni 1 N-type Jack
MMO58007NF no element/7 Omni 1 N-type Jack
ECO6-5500 no element/6 Omni 1 N-type Plug
M6060060MO13620O 6/6 Omni 6 RP-SMA Plug
ANT-77555-OUT S24517PT36RSM 8/10.7 Panel 3 RP-SMA Plug
T24060MP13620 6/noelement__Panel 3 RP-SMA Plug
T58070MP13620 Noelement/7__Panel 3 RP-SMA Plug
M6060070MP13620 6/7 Panel 6 RP-SMA Plug
ANT-74520-OUT S245112PT36RSM 10.9/13.5 Panel 3 RP-SMA Plug
ANT-5007-OUT MA-WA56-DP25NB No element/23.5 Panel 2 N-type Jack
ANT-7360P-IN FDE_ACBSMA-BGP 3/5 Omni (Paddle
or Rubber
Ducky)
1 RP-SMA
S24493TS 3/4 Omni 3 RP-SMA
M6025040MO1D3620 2.5/4 Omni 3 RP-SMA
M6025040MO1D2420M 2.5/4 Omni 3 RP-SMA
W arning!
Always install the four MP-522E antennas before supplying power to the MP. Failure to
do so can cause damage to the unit.