User's Manual

Indoor Mobility Point™ Quick Start Guide
39
Trapeze Networks
Figure 1–33. 10/100 Cat 5 Cable Installation
1. Insert a Cat 5 cable with a standard RJ-45 connector as shown in Figure 1–33. For connection to
an MP, use a straight-through cable.
2. When the link is activated, observe the MP LED for the port on the MX:
Configuring the MP
To configure the channels, power settings, and other MP parameters, see the following:
❑ Trapeze Mobility System Software Quick Start Guide
❑ “Configuring MP Access Points” chapter in the Trapeze Mobility System Software Configuration
Guide
External Antenna Connectors
The Indoor MPs (except for the MP-82 and MP-432) have connectors for attaching optional external
antennas. Table 1– 3 below lists the Trapeze-supported external antenna models.
Note:
The numbers in parentheses in the table below are the numbers that appear on the
back of an 802.11a antenna reflector plate. To verify an 802.11a external antenna
model number, look for the number in parentheses
Note:
The MP-82 has three external antenna connectors, but external antennas are not
supported at this time.
Mobility Exchange
MX-20
Ethernet cable
(Cat 5 cable)
MP, switch, server
or other device
Ethernet port