User's Manual

Indoor Mobility Point™ Quick Start Guide
38
Trapeze Networks
MP-522E Installation Antenna Orientation
Adjust the MP-522E antennas as shown below for optimal polarization.
Wall Mount
Ceiling Mount
Connecting an MP to an MX
You can connect an MP directly to an MX or indirectly to the MX through an intermediate Layer 2 or
Layer 3 network. If you are connecting the MP directly to an MX, use the following procedure to
insert the cable into the MX and verify the link.
You can use the CLI or RingMaster to configure an MP connection. If you are installing the MP as a
Mesh AP in a WLAN Mesh or wireless bridge configuration, you must configure the MP connection
before deploying the MP in the final location. (See the Mobility System Software Configuration Guide
or the Configuration Guide.)
Figure 1–33 below shows how to insert a Cat 5 cable into 10/100 Ethernet port on an MX. Refer to this
figure as you perform the procedure.